Installation Instructions
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance
with the National Electrical Code and local regulations.
To assure full compliance with local codes and
regulations, check with your local electrical inspector
before installation. To prevent electrical shock, turn
off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
45 SPRING STREET • P.O. BOX 9575
NEW HAVEN, CONNECTICUT 06535-0575
NOTE: This instruction sheet covers several fixture styles.
Lamp type and ballast may vary slightly from that shown,
although installation is the same.
WARNING: FOR SUPPLY CONNECTIONS USE
WIRE RATED FOR AT LEAST 90°C.
CAUTION: MAKE CERTAIN WIRES ARE NOT
PINCHED BETWEEN PARTS.
CAUTION: MAXIMUM WATTAGE AS MARKED ON
FIXTURE MUST NOT BE EXCEEDED.
1. Place first fixture in finished cove assembly
2. Insert flange of fixture into proper slot (see
3. Fasten fixture to sheetrock support bracket.
Comentarios a estos manuales