
3. Traktor Pro 2 Mapping Details
18
ond, FX HOLD, is a momentary button that reverses the On state of the eects. So if the eects are
o, it will turn them on momentarily, and if they are on, it will turn them o momentarily
Pitch Bend
The pitch bend buttons also double as pitch buttons while holding pitch. This is useful to increase
the tempo throughout the night during a “beat sync” set. Note: Pitch bending only works while beat
sync is on if the “Tempo Sync” option is selected in the preferences.
3.4 Pads
The velocity pads are a lot fun to control Traktor’s eects units. The eight pads are ideal to control
each FX unit’s 4 parameters. The top row controls FX unit 1 and the bottom row controls FX unit 2.
We found this conguration works better for hand placement, rather than splitting the units down
the middle like the grid.
Dry/Wet
Most included presets set the D/W to Wet. Applying pressure to this pad reduces the wet signal, and
releasing it returns to Wet. Releasing the pad while holding Shift, sets the signal to Dry.
Buttons / Knobs
The next three pads control the three buttons and knobs in Traktor’s FX units together.
In Group Mode, pressing a pad turns on its eect and applying pressure increases the amount of
the eect. Releasing a pad turns o its eect. Holding Shift disables the knob and only activates the
button. If FX On is active in the grid, the pads only control the knobs (this way eects don’t turn o
when releasing the pads).
In Single Mode, the pads only aect the knobs. When holding Shift, they only aect the buttons.
3.5 MIDI Notes
If you plan to create your own mappings or edit this one, note that Traktor transposes MIDI Note
messages up one octave from the TWEAKER’s mapping. So all notes are one octave higher in Traktor
than shown on TWEAKER’s MIDI map (i.e. C#-2 on TWEAKER is equal to C#-1 in Traktor).
Comentarios a estos manuales